13
2.3 Initial Settings
Set up the SSAS as follows:
1. FELCOM 15/FELCOM 12: Press [F8], [F2] to show the System Setup menu.
FELCOM 16: Press [F8], [F1] to show the System Setup menu.
2. Press [↓] to choose Command Window and then press the [Enter] key.
Command Window
RFCONCPU ***
[ Main Menu ]
1. Remote Box Setup
2. Internal GPS Setup
Enter JOB No. :
Command Window
RFCONCPU ***
[ Main Menu ]
1. Remote Box Setup
Enter JOB No. :
FELCOM 15/FELCOM 16
FELCOM 12
3. Type “furunoservice” (without quotation marks) in the Enter JOB No. field and then press
the [Enter] key. The prompt PASSWORD appears.
4. Enter password (see FURUNO Information for SSAS) then press the [Enter] key. Then,
the item Main Menu is displayed in reverse video.
5. Press [1], [Enter], [1], [Enter]. One of the following windows appears.
FELCOM 16
FELCOM 15
[ SSAS I/F (IC-312) ]
1. DTE2 Port
2. DATA Port
3. OFF E: Exit
Enter No.:
FELCOM 12
[ DMC ]
1. SSAS(IC-307)
2. DMC
3. OFF
4: SSAS(Momentary SW) E: Exit
Enter No.:
[ SSAS ]
1. ON(IC-307)
2. OFF
3: Momentary SW (for USCG)
E: Exit
Enter No.:
6. FELCOM 15/FELCOM 16: Press [1], [Enter]. This enables the SSAS functions.
FELCOM 12: Choose the port where the SSAS unit is connected and then press the
[Enter] key.
7. Press the [Esc] key several times to close the menu.
Note: Test the SSAS button and SSAS report for proper operation, referring to paragraphs
3.4 and 3.5, respectively.
To Next Page
Loading...
