DP-5
D1-3
Function Item Default Setting Note
*Remote B Mode OFF
DSC
*Rate (baud) 4800
4800
*Start Bit 1Bit
1Bit
*Date Bit 7Bit
7Bit
*Stop Bit 2Bit
2Bit
*Parity Bit Even
Even
*Delimiter CR
CR
MIF Tune OFF OFF
Pass word: DP5(Caps Lock)
Don’t change.
Note) DSC is connected to
REM-B port.
Freeze OFF OFF
AGC OFF OFF
CIF/NMEA Mode CIF
CIF or
NMEA
F6:Teminal
CIF Rate (baud) 4800 CIF:4800
Pass word: DP5(CAPS LOCK)
Jumper setting: JP-2 on the
CONTROL Board.
Monitor OFF Line OUT
Line In Level 4 4
Line Out Level 4 4
Beep Level 4 4
CRT Economy Mode OFF ON
File Partial View OFF ON
*Slave Delay 5 msec
5 msec
*BK Timing Pre tone 10 msec
10 msec
*Post Tone 0 msec
0 msec
*Mute Timing Pre BK 0 msec
0 msec
*Post BK 0 msec
0 msec
Pass word: DP5(Caps Lock)
Note) Refer to next page.
*Timing depends on the type
of the transceiver unit
connected.
Reception Alarm ON ON
Time System OFF UTC
Time & Date 90/1/1 Setting
Printer PP-500
PP-500
PP-500/510 is connected.
Header File Name ON ON
Time ON ON
Footer OFF OFF
Language Normal Normal
Self Test
Version No.
Ver x.xx
F8: System
Modem Version No.
Ver x.xx
*: Password : [DP5] is needed for change of these setting.
To Next Page
Loading...
