DSC-6
B2-9
7. Clearing Contents of S-RAM and EEROM
After replacing the ROM on the CONTROL board or if the unit is not working
properly, be sure to press the NMI switch on the CONTROL board after turning on
the unit, to clear contents of S-RAMs.
Procedures
1. Press the NMI switch S1 on the CONTROL board with the unit turned on.
2. Since the power is automatically cut off, turn the power on.
3. The screen should look something like this:
4. Clear to RAM 1, RAM 2 or EEROM.
RAM 1 or RAM 2 clear
When Select to RAM 1 or RAM 2, press the [ENT] key;
The power is automatically cut off. Turn the power on again manually.
Clear <Do not clear>
NO RAM1 RAM2 EEROM
To Next Page
Loading...
