Appendix
AP1-13
1.5 Installation of Pre-amp unit and coaxial cable
1. Mounting of Antenna (FAX-5, 2.6 m whip antenna)
Fix the FAX-5 (pre-amp unit) to the mounting mast (35-90 mm) with hose clamps.
Screw the whip antenna into the FAX-5. Coat connection point with putty to
waterproof.
2. Switching to coaxial cable with armor
To switch to coaxial cable with armor (RG-10/UY);
1. Attach a coaxial connector (MP-3) about 40-60 cm from the bottom of the FAX-5.
2. Remove 15-25 cm of the sheath of the cable RG-l0/UY and attach connector MP-7 to
the cable.
3. Attach relay connector M-A-JJ between connectors MP-3 and MP-7.
4. Cover connectors with self-vulcanizing tape followed by vinyl tape to waterproof.
To Next Page
Loading...
