Furuno FS-1562 - Page 163

DP-6
D2-11
4. To update the terminal program,
(Terminal Program for Standard)
- press keys, [I], [N], [S], [T], [A], [L], [L], and [Enter], successively.
Then, the updating will proceed automatically by following the instructions as shown
below:
1) After a message, "Overwrite A:\DP10>----- (Yes/No/All)?", has appeared,
- Then, press keys, [A] and [Enter] , successively.
2) After a message "Press any key to continue." has appeared,
- press any key, for example, [Enter] key.
(Terminal Program for Russian)
- press keys, [R], [U], [S], [I], [N], [S], [T], and [Enter], successively.
Then, the updating will proceed automatically by following the instructions as
shown below:
After a message "Press any key to continue." has appeared,
- press any key, for example, [Enter] key.
Reference)
(1) Press [Alt] key while pressing left [Shift] key, alternates the language for
composing messages between English and Russian.
(2) To install the new program for English version,
- successively press keys, [I], [N], [S], [T], [A], [L], [L], and [Enter].
The updating automatically proceeds by following instructions to be displayed.
5. Then, the updating will be finished, displaying the prompt "A:\>".
6. Turn off once and on again the terminal unit.
Confirming program version
To confirm the version of the Terminalv program, execute "[F6]:System ---> Self-Test".