K1-12
8. The prompt "A:¥>" will appear on the screen.
9. Check to be sure that the system file have been written in the Flash ROMs(C-drive).
- Change to the C-drive by pressing keys [C],[:], and [Enter], successively.
The prompt "C:¥>" will appear on the screen.
10. Press keys [D], [I], [R], and [Enter] successively to confirm that "COMMAND.COM"
files are included in C-drive.
11. Once turn off power, and restore the changed items to their original settings, referring
to the procedures described in "page K1-8 3.5 Changing BIOS settings" and "page K1-10
3.6 Changing DIP SW and Internal Connector".
BIOS settings
- Floppy Drive A: 1.44 MB, 3 1/2 Restore to "Not installed".
- Floppy Drive B: Not installed Restore to "1.44 MB, 3 1/2".
Changing DIP SW settings and the connector connection
- # 5, # 6 ON Restore to "# 5, # 6 OFF".
Restore the connection of FD drive connector.
- A Drive Restore to "B-drive".
12. Turn on power, and continue to operate according to the operational instructions
displayed. A date and time input display will appear, but it is not necessary to input date
and time.
"Current date is XX",
- Pressing key [Enter].
"Current Time is XX" ,
- Pressing key [Enter].
13. The prompt "A:¥>" will appear on the screen.
14. Press keys [D], [I], [R], and [Enter] successively to confirm that "COMMAND.COM"
files are included in A-drive.
15. Install the terminal software according to "page K1-1".
IB-581
To Next Page
Loading...
