4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1650W)
17
4. Dismount heat sink from chassis assembly by unfastening four screws on the ANLG
board and disconnecting the connector of the mini pin coaxial cable.
Handling of Coaxial Cable
• Do not touch the connector with bare hands;
use gloves.
• Use radio pincers to remove, and pull out
straightly.
• Plug in connector straightly.
A
Screws X 4
ANLG board
GN-8091
Heat sink
Mini pin coax. cable
Mini pin connector
Chassis assembly
5. Take off the mini pin coaxial cable from J2 on the GN-8091.
6. Open the lid of GR-7000A
7. Connect cable assy. S.FL2-2LP0.7-D-WHT (175) (supplied) to J1 of GR-7000A
To Next Page
Loading...
