Furuno NAVpilot-700 - 3 Initial Settings; About Initial Settings, Menu Operation3-1

3-1
3. INITIAL SETTINGS
3.1 About Initial Settings, Menu Operation
This chapter shows you how to enter initial settings, on the [INSTALLATION] menu. The
menu contains some items that may not apply to your system. To return to the [INSTAL-
LATION] menu, push the MENU key.
Minimally, the following settings must be done:
• Ship’s characteristics
• Rudder Reference Unit (RRU) setup*
• Air bleeding
• Rudder limit*
• Rudder test
• Helm sensor test* (For Accu-Steer FPS only)
*: Not necessary in case of Fantum Feedback
TM
.
All operations on the menu are done with the Course control knob and MENU key
Control, key Usage
Course control knob Rotate the knob to select a menu item then push the knob.
Rotate the knob to select setting or enter alphanumeric value
then push the knob to confirm setting. This manual refers to the
Course control knob as “knob”.
MENU key Go to previous screen.
Course control knob
(pictured: NAVpilot-700)