How to clean dust on Furuno Marine Equipment LCD?
To clean dust from the LCD of your Furuno Marine Equipment, carefully use tissue paper and an LCD cleaner to prevent damage. Alternatively, use an LCD cleaner and wipe slowly with lens paper to dissolve any dirt or salt.
Why check the ground terminal condition on Furuno Marine Equipment?
The ground terminal on your Furuno Marine Equipment should be checked for a tight connection and any signs of corrosion. Clean or replace the ground wire as necessary to ensure proper function.
What is the best way to remove dust from Furuno Marine Equipment cabinet?
To remove dust from the cabinet of your Furuno Marine Equipment, use a dry, clean cloth.
General| Type | Autopilot System |
|---|---|
| Power Supply | 12/24 VDC |
| GPS Interface | NMEA0183, NMEA2000 |
| Course Accuracy | ±1° |
| Navigation Interface | NMEA0183, NMEA2000 |
| Operating Temperature | -15°C to +55°C |
| Display | Color LCD |
| Control Mode | Auto, Standby, Track |
| Operating Modes | Auto, Nav, Wind |
| Waterproof Rating | IP56 |
| Compass System | Fluxgate |
| Steering Modes | Auto |
Explanation of safety icons and their meanings to ensure safe operation.
Critical safety rules and procedures to prevent hazards.
Procedures for turning the system on, off, and initial startup checks.
How to use and configure the AUTO steering mode.
Instructions for navigating to waypoints using the NAV mode.
Functionality for immediate manual control to evade obstacles.
How to access, set, and manage system alarms.
Adjusting core operational parameters based on vessel and environment.
Running diagnostic tests to identify and resolve system issues.
Detailed steps for physically mounting the control unit.
Instructions for correctly connecting all system components.
Configuring settings specific to the vessel's type and characteristics.
Essential setup and calibration steps before system operation.
Calibrating sensors and tuning rudder behavior for accurate performance.
To Next Page
