Furuno NAVpilot-711C - How to Set the Steering Behavior of Your Boat after You Arrive to a Waypoint

2. STEERING MODES
2-8
2.3.4 How to set the steering behavior of your boat after you arrive
to a waypoint
When you arrive to the last waypoint in a route, the FishHunter
™
mode can be activat-
ed automatically to steer the boat according to the FishHunter
™
mode preset. For de-
tails of each preset, see section 2.6.
This function is not available with a sailboat.
To enable the FishHunter
™
mode and set the steering behavior, do as follows:
1. In the NAV mode, long press the key to show the menu.
2. Rotate the Course control knob to select the current set-
ting for [After Arrival] then push the knob.
[After Arrival] also appears on the [NAV Option] menu.
For Fantum Feedback
™
, only [GO Straight] and [Orbit to
STBD] appear.
• [GO Straight]: Cruise straight after arriving at the last
waypoint.
• [Orbit to PORT]: Orbits to PORT around waypoint.
• [Orbit to STBD]: Orbits to STBD around waypoint.
• [Figure Eight PORT]: Turns to PORT in a figure-eight pattern.
• [Figure Eight STBD]: Turns to STBD in a figure-eight pattern.
• [Square PORT]: Turns to PORT in a square pattern.
• [Square STBD]: Turns to STBD in a square pattern.
3. Rotate the Course control knob to select an option then push the knob.
4. Press the key to close the menu.
GO Straight
Orbit to PORT
Orbit to STBD
Figure Eight PORT
Figure Eight STBD
Square PORT
Square STBD