3. ALARMS
3-4
3.6 XTE Alarm
The XTE alarm, which is available in the NAV mode, alerts you when the course error
has exceeded the XTE alarm setting.
1. Open the [Alarm] menu.
2. Rotate the Course control knob to select [XTE Alarm] then push the knob.
3. Rotate the Course control knob to select [ON] or [OFF] then push the knob. For
[OFF], go to step 6.
4. Rotate the Course control knob to select the current XTE alarm value then push
the knob.
5. Rotate the Course control knob to set the XTE alarm value then push the knob
(Setting range: 0.001 - 9.999 NM).
6. Press the key three times to close the menu.
3.7 Arrival Alarm
The arrival alarm alerts you when you are within a specific distance from a waypoint.
1. Open the [Alarm] menu.
2. Rotate the Course control knob to select the current setting for [Arrival Alarm]
then push the knob.
3. Rotate the Course control knob to select [ON] or [OFF] then push the knob. For
[OFF], go to step 6.
4. Rotate the Course control knob to select the current arrival alarm value then
push the knob.
5. Rotate the Course control knob to set the arrival alarm value then push the knob
(setting range: 0.01 - 9.99 NM).
6. Press the key three times to close the menu.
Own ship
position
Intended
course
: Alarm area
Destination
Alarm
setting
Alarm
range
Waypoint
: Alarm area
Own ship
To Next Page
Loading...
