Furuno NAVpilot-711C - Trip Distance Alarm, Trip Distance Reset; How to Set the Trip Log Alarm; How to Reset the Trip Distance

3. ALARMS
3-7
3.11 Trip Distance Alarm, Trip Distance Reset
3.11.1 How to set the trip log alarm
The trip log alarm alerts when you have traveled a specific distance.
1. Open the [Alarm] menu.
2. Rotate the Course control knob to select the current setting for [Trip Log] then
push the knob.
3. Rotate the Course control knob to select [ON] or [OFF] then push the knob. For
[OFF], go to step 6.
4. Rotate the Course control knob to select the current setting value then push the
knob.
5. Push the Course control knob to set the value then push the knob.
6. Press the key three times to close the menu.
3.11.2 How to reset the trip distance
Follow the procedure below to reset the trip distance to zero.
1. Open the [Alarm] menu.
2. Rotate the Course control knob to select the option for [Clear Trip Log] then push
the knob.
3. Rotate the Course control knob to select [Yes] then push the knob.
The confirmation message shown below appears.
4. To reset the trip distance, push the Course control knob. If you do not want to
reset the trip distance, push any key other than the Course control knob.
5. Press the key three times to close the menu.
Clear Trip Log
Are you sure?
Yes: Push ENTER knob
No

: Push another key