2. STEERING MODES
2-36
How to set the tack timer
You can set the amount of time to wait before starting
a turn (tack time), after selecting the turn from the turn
menu. When you enable the tack timer, the countdown
window shown right appears after selecting the turn
from the turn menu.
1. In the WIND mode, long press the key to open the menu.
2. Rotate the Course control knob to select the current setting for [Tack Timer] then
push the knob to show the tack timer options.
[Tack Timer] also appears on the [Wind Option] menu.
3. Rotate the Course control knob to select [ON] then push the knob.
4. Rotate the Course control knob to select the current timer value then push the
knob.
5. Rotate the Course control knob to set the timer value then push the knob (setting
range: 1 - 99 sec.).
6. Press the key to close the menu.
2.11.5 How to reverse a heading change using the keys/knob
Heading changes may be reversed using the or key, or by using the Course
control knob.
1. In the WIND mode, long press the key to open the menu.
2. Rotate the Course control knob to select [Rotokey Wind Mode] then push the
knob.
[Rotokey Wind Mode] also appears on the [Wind Option] menu.
3. Rotate the Course control knob to select the appropriate item, then push the
knob.
• [WA Inc/Dec]: Turn the Course control knob clockwise, or press the key
change the wind direction settings in the starboard direction and steer the bow
to port. Turn the Course control knob counter-clockwise, or press the key
change the wind direction settings in the port direction and steer the bow to star-
board.
Note: The and keys will not function in Dodge mode.
• [CRS Change]: Controls are the opposite of [WA Inc/Dec].
4. Press the key to close the menu.
Tack starts after
10 Seconds
Setting value of the tack timer
To Next Page
Loading...
Need help?
General
