To Next PageTo Next PageHow to clean dust on Furuno Marine Equipment LCD?
To clean dust from the LCD of your Furuno Marine Equipment, carefully use tissue paper and an LCD cleaner to prevent damage. Alternatively, use an LCD cleaner and wipe slowly with lens paper to dissolve any dirt or salt.
Why check the ground terminal condition on Furuno Marine Equipment?
The ground terminal on your Furuno Marine Equipment should be checked for a tight connection and any signs of corrosion. Clean or replace the ground wire as necessary to ensure proper function.
What is the best way to remove dust from Furuno Marine Equipment cabinet?
To remove dust from the cabinet of your Furuno Marine Equipment, use a dry, clean cloth.
General| Type | Autopilot System |
|---|---|
| Power Supply | 12/24 VDC |
| GPS Interface | NMEA0183, NMEA2000 |
| Course Accuracy | ±1° |
| Navigation Interface | NMEA0183, NMEA2000 |
| Operating Temperature | -15°C to +55°C |
| Display | Color LCD |
| Control Mode | Auto, Standby, Track |
| Operating Modes | Auto, Nav, Wind |
| Waterproof Rating | IP56 |
| Compass System | Fluxgate |
| Steering Modes | Auto |
