Furuno NAVpilot-711C - 3.3 Optimus compatible software versions

8
The NavPilot-711C will display OVRD mode during the following conditions. When
operating the Helm or Joystick, or in one of the Optimus operating modes such as Position
Hold, Heading Hold or Position and Heading Hold.
The Seastar Optimus system automatically
incorporates a safety feature called
“Override”. When a user moves the helm
or joystick, an override signal coming from
the Seastar Optimus system automatically
sets the Navpilot to STBY (Standby). When
this happens, the NAVpilot-300 will display
the [OVRD] icon on the top of the screen.
Note: Two rudders are controlled separately during Optimus operation modes.
Consequently, the Optimus PCM alternatively outputs two rudder angles. The
NavPilot will toggle the display of the rudder angles during the OVRD mode.
3.3 Optimus compatible software versions
See “Product Information” on the Optimus CANtrak display and confirm that the PCM
software is software Rev T or above. (Menu -> Devices -> Main Display -> Product
Information).
PRODUCT INFORMATION
Part Number:
******
Serial Nu mber:
******
Software:
******Rev *
Bootloader:
******Rev*
(See appendix for specific 12vdc or 24vdc Optimus BUS connection diagrams
and the Navpilot 711C Installation manual for further information)
All brand and product names are registered trademarks, trademarks or service marks of
their respective holders.