Furuno NAVpilot-711C - Lever-Type Remote Controller (FAP-6221, FAP-6222)

2. STEERING MODES
2-27
2.10.2 Lever-type remote controller (FAP-6221, FAP-6222)
The lever-type controller has an ON/OFF switch and works like an NFU remote con-
troller. When the remote controller is turned on, the user operates the remote control-
ler to move the rudder and the rudder stops once operation of the remote controller is
stopped.
To use this function, set the remote mode of the remote controllers to [NFU] on the
[RC Setup] menu (see section 7.17).
1. Turn on the remote controller to show " " on the control unit.
2. Position the lever for the direction.
3. Turn off the remote controller to terminate the REMOTE mode.
ON
䋺
Pull the lever.
Lever-type
Lever-type
Turn to PORT Turn to STBD
OFF
䋺
Pull the lever.
Lever-type