Furuno RC-1800T - Location of Terminal Blocks Inside the Rack Console; Connection of Equipment Installed in the Console

2. WIRING
2-2
2.2 Location of Terminal Blocks Inside the Rack
Console
The figure below shows the location of the terminal blocks inside the console.
Terminal blocks (Top view)
The locations for terminal blocks are shown in the figure below.
2.3 Connection of Equipment Installed in the Con-
sole
For connections at the equipment side, see respective installation manuals.
• FELCOM18: Installation Manual (IME-56740-x)
• FS-1575/FS-2575: Installation Manual (IME-56770-x)
• PP-520: Operator’s Manual (OMC-50802-x)
The terminal blocks TB1 to TB4 have cables preattached, and the cables destinations
are marked on the cables. For the printer cables, pull them out from the grommet on
the top cover of the console then connect them to the printer. See section 1.5.
Terminal Block (TB1 - TB4)
Terminal Block (TB1 - TB4)
TB1: For power cable
TB2 - TB4: For signal cable
TB1
TB2 TB3 TB4