Furuno RD-30 - Powering the Device On;Off; Adjusting Screen Brightness and Contrast

2
Flush mounting
There are two types of flush mount kits, F type and S type. For details, see
the outline drawings at the back of this manual.
F type
Flush mount kit F (Type: OP20-29, Code No.: 000-041-405)
No. Name Type Code No. Qty Remarks
1 Cosmetic Panel 20-016-1051 100-251-370 1
2 + Tapping Screw 5x20 SUS304 000-802-840 4
3 Hex Bolt M6x12 SUS304 000-862-127 2
4 Spring Washer M6 SUS304 000-864-260 2
1. Make a cutout of 183 X 92 mm.
2. Attach the cosmetic panel (supplied) to the display unit with hex bolts
(M6X12, supplied) and spring washers (M6, supplied).
3. Fix the display unit to the mounting location with four tapping screws
(5X20, supplied).
S type
Flush mount kit S (Type: OP20-17, Code No.: 000-040-720)
No. Name Type Code No. Qty Remarks
1 Fixing Metal 20-007-2401 100-183-190 2
2 Wing Bolt M4x30 YBSC2
MBN12
000-804-799 4
3 Hex Bolt M6x12 SUS304 000-862-127 2
4 Wing Nut M4 YBSC2
MBN12
000-863-306 4
5 Spring Washer M6 SUS304 000-864-260 2
1. Make a cutout of 167 X 92 mm.
2. Attach two fixing metals (supplied) to the display unit with hex bolts
(M6X12, supplied) and spring washers (M6, supplied).
3. Screw four wing bolts (supplied) into wing nuts (supplied).
4. Fasten the display unit to the mounting location with four sets of wing
bolts and nuts assembled at step 3.
www.reelschematic.com
www.reelschematic.com