Furuno SC-60 - Programming user beacon stations

3. OPERATION
3-15
LIST
a) The following display appears after pressing the [ENT] key at step 7.
STATION (NEAREST)
[EXIT] [USER]
310.0 29.1 nm 92
287.0 56.7 nm 134
292.0 160 nm 320
321.0 234 nm 134
302.0 426 nm 121 *
Beacon station
frequency
Range and bearing from own
ship to beacon station
(Reference only)
* = User-registered station
Beacon station display
b) Choose desired station with the Omnipad.
c) Press the [ENT] key.
8. Press the [DISP] key to close the menu.
3.10.2 Programming user beacon stations
The user may program 20 DGPS beacon stations from which to use in selection
of DGPS beacon station. Whenever a new station comes into operation, you can
add it to the list.
1. Press the [MENU] key to open the menu.
2. Choose DGPS and press the [ENT] key.
3. Choose STATION and press the [ENT] key.
4. Choose LIST and press the [ENT] key.
5. Choose USER and press the [ENT] key to show the STATION (USER)
display.
STATION (USER)
[EXIT] [NEW?] [CLR?]
01
02
03
04
05
06
STATION (USER) display
6. Choose “NEW?” and press the [ENT] key.