3. OPERATION
3-16
NEW USER CHANNEL
FREQ : 310.0kHz
RATE : 200BPS
LAT : 37
˚
59’N
LON : 133
˚
00’E
EXIT? SAVE?
NEW USER CHANNEL display
Note: For steps 7-10 use the Omnipad to enter data. Choose location with
◄ or ►; change value with ▲ or ▼.
7. Press the [ENT] key, enter frequency of the station, and press the [ENT] key.
8. Press the [ENT] key, enter baud rate of the station, and press the [ENT] key.
9. Press the [ENT] key, enter latitude of the station, and press the [ENT] key.
10. Press the [ENT] key, enter longitude of the station, and press the [ENT] key.
11. Choose “SAVE?” and press the [ENT] key.
12. Press the [DISP] key to close the menu.
3.10.3 Editing user beacon stations
1. Press the [MENU] key to open the menu.
2. Choose DGPS and press the [ENT] key.
3. Choose STATION and press the [ENT] key.
4. Choose LIST and press the [ENT] key.
5. Choose USER and press the [ENT] key.
6. Choose a station from the list and press the [ENT] key. The display looks
something like the one below.
FREQ : 310.0kHz
RATE : 200BPS
LAT : 37
˚
59’N
LON : 133
˚
00’E
EXIT SAVE? ERASE?
Display for editing user channels
7. Choose item, press the [ENT] key, edit data, and press the [ENT] key.
8. Choose “SAVE?” and press the [ENT] key.
9. Press the [MENU] key twice to finish.
To Next Page
Loading...
