22
5 Software Configuration with file data
The VR-3000/S can be configured by using the configuration data (“ini” file) on the
recording medium of the PC in three steps: uploading the data to VR-3000/S, loading
the data to the system, and then, saving the data to the DRU.
First, upload the file data from PC to VR-3000/S. To do so,
1. Go to Configuration menu.
2. Press Handle CONFIG-file button.
3. Press Upload button. CONFIG-file upload window appears.
4. Select the file, and then press UPLOAD button.
5. Press Back button to go back to Handle CONFIGRATION-file menu.
Next, load the data to VDR system.
6. Press Sysload button in Handle CONFIGRATION-file menu.
7. Make sure that no error message appears. Table below list the typical error
messages.
Error message Possible cause Action
Unable to lock
configuration before
importing
System error Reboot system.
Missing file No data uploaded Upload configuration data.
Illegal values in uploaded
configuration file
Too many cards/channels
in configuration data
Check configuration data for
correct setting.
Unable to send
reconfiguration-request to
VR-3000/ S
System is not running
properly.
Solve system error.
8. Press Back button to go back to Handle CONFIGRATION-file menu
And, then save the data onto the flash memories on the DRU and backup hard disk.
9. Press Save (Save CONFIGURATION) button.
10. Press Save (Save CONFIGURATION to BOOTFLASH) button.
11. Reboot VR-3000/S.
To Next Page
Loading...
