4
12. Select a sub menu by pressing a desired button in Main menu.
13. In the sub (card) menu;
1. First, press “Channels” button.
2. Press “Next” button to select the channel for editing.
3. Press “Edit” button.
4. Edit as required. (Select “Submit” to save the change.)
Note: When Junction Box (IF-8530) is connected, checked the “Remote Junction Box
selected” check box. And confirm the “Eth 2 IP addr : 172.31.24.1” and “Eth 2 IP mask :
255.255.0.0”. Serial channel (SI08-SI15), Analog channel and Digital channel
configuration become effective because it checks the “Remote Junction Box selected”
check box.
3.1 Audio (Audio Channel)
To configure audio channel;
1. Select “Audio Channels” in
main menu. The Audio
Card menu appears,
showing the status of Audio
I/F card in the Data
Processing Unit.
Fig.3.4 Audio card menu
2. Press Channels button to
show Audio Channel menu.
Fig.3.5 Audio channel menu
Audio Card
Back
Edit
Active: X
Name: AD LINK 9111DG
Node id: 1
Number of channels: 5
udio codec: Dynamic Range 64 codec
Channels
Audio Channel
Back Monitor
First Previous Next Last Edit 0-4 Audio ch Goto
Active: x
Channel#: VHF1
Channel id:
Sample rate: 15625 Hz
Source: LEFT SIDE BRIDGE VHF
Sample data size: 8-bit Fixed
Source type:
Note:
To Next Page
Loading...
