18
3.2 Error Codes
Error codes may appear on the status display on the Power Control Panel to alert to possible
trouble. Below is a list of those codes.
System soft ware: 2450031-02
Error Code Error Name Description Action
--4
--3
--2
--1
---
Normal operation. “--X” (X: 1,2,3,4)
means number of existing recording
area in the HDD. “---” is shown at
startup or when recognizing HDD.
HDD BACK_UPHDD_MIS
SING
Backup HDD not connected to VDR,
or no memory area.
1) SAVE button pressed and backup HDD
removed: Replace backup HDD.
2) Other situations: Reset VDR. If normal
operation not restore, request service
018 Backup HDD No
Connection
This indicates that the BACKUP has
been disconnected more than 120
seconds.
Connect BACKUP HDD or investigate LOG
and repair/replace.
022 DRU No Connection DRU has been discontinued more
than 120 seconds.
Connect DRU again or investigate LOG
and repair or replace.
026 GPS Large Time
Difference
This indicates that the time
difference between system time and
time supplied by UTC source is
more than the specified time.
Restart VR-3000/S. Try to see if the CMOS
clock is set correctly. If not, set it and
restart VR-3000/S. If yes, find out why the
time source device GPS is delivering “out
of bands” time info.
042 Radar No
Connection
One of the active/enabled video
channels can not grab from the
channel. This can be either because
radar is turned OFF or wrong
configuration.
If radar is turned OFF, press ACK on the
RAP to silence alarm. Turn on radar. If no
error appears, the system is normal. If error
occurs again, check cable connections or
setting.
082 RAP No Connection RAP is missing. Connection to RAP
is lost.
When RAP and AP error codes are “082”,
check cable connected to RAP and
reconnect RAP.
When RAP error code is “082” and AP error
code is “084”, see error code “082+084”.
084 AP No Connection No alarm panel connection. When RAP and AP error codes are “084”,
check connection to alarm panel.
When RAP error code is “082” and AP error
code is “084”, see error code “082+084”.