DAB Playback
DAB broadcasts are not available in all regions. When the stereo is not set to a compatible region, the DAB
source is not available.
See the troubleshooting section if you cannot access the DAB source or if DAB stations are not playing
properly. (The stereo does not receive DAB stations, page 9)
Setting the Tuner Region
You must select the region you are in to receive DAB stations properly.
1 Select > SETTINGS.
2 Select TUNER REGION.
3 Select the region you are in.
Scanning for DAB Stations
NOTE: Because DAB signals are broadcast in select countries only, you must set the tuner region to a location
where DAB signals are broadcast.
1 Select the DAB source.
2 Select to scan for available DAB stations.
When scanning is complete, the first available station in the first ensemble found begins playing.
NOTE: After the first scan is complete, you can select again to re-scan for DAB stations. When the re-
scan is complete, the system starts playing the first station in the ensemble you were listening to when you
started the re-scan.
Changing DAB Stations
1 Select the DAB source.
2 If necessary, select to scan for local DAB stations.
3 Select or to change the station.
When you reach the end of the current ensemble, the stereo automatically changes to the first available
station in the next ensemble.
TIP: You can hold or to change the ensemble.
Selecting a DAB Station from a List
1 Select the DAB source.
2 If necessary, select to scan for local DAB stations.
3 Select > BROWSE > STATIONS.
4 Select a station from the list.
Selecting a DAB Station from a Category
1 Select the DAB source.
2 If necessary, select to scan for local DAB stations.
3 Select > BROWSE > CATEGORIES.
4 Select a category from the list.
5 Select a station from the list.
DAB Presets
You can save your favorite DAB stations as presets for easy access.
You can save up to 15 DAB-station presets.
6 DAB Playback
To Next Page
Loading...
Need help?
General
