Cleaning the Device
1 Dampen a soft, clean, lint-free cloth with fresh water.
2 Gently wipe the device.
Troubleshooting
The stereo does not respond to key presses
• Hold until the stereo turns off, and turn it on again to reset the stereo.
• Disconnect power to the stereo for two minutes to reset the stereo.
My Bluetooth audio is interrupted by short breaks
• Ensure the media player is not covered or obstructed.
Bluetooth technology performs best with line-of-sight operation.
• Bring the media player within 10 m (33 ft.) of the stereo.
• Turn off the DISCOVERABLE setting after pairing a Bluetooth device to the stereo.
The stereo does not display all song information from my Bluetooth source
The availability of song information, such as song title, artist name, and track duration, depends on the
capability of the media player and music application.
Album cover artwork and shuffle and repeat status icons are not supported by this stereo on Bluetooth
technology.
Reducing Unexpected Noise
If the stereo is subject to strong electrical interference, this interference might be heard through the speakers.
You should take appropriate action to suppress or reduce the noise.
• Add clip-on ferrite beads to the cables connected directly to the product.
• Add clip-on ferrite beads to the device in the vessel that is causing the interference.
• Disconnect the AUX input cable from the RCA connector when it is not used.
• For additional information, go to www.fusionentertainment.com and contact Tech Support.
The stereo does not receive DAB stations
NOTE: The Fusion
®
MS-RA60 includes a built-in DAB module and receives DAB signals through a standard
AM/FM antenna.
• Ensure the stereo is set to a tuner region where DAB stations are broadcast. (Setting the Tuner Region,
page 6)
• Connect a third-party powered DAB antenna to improve DAB reception.
• For additional information, go to www.fusionentertainment.com and contact Product Support.
Appendix 9
To Next Page
Loading...
Need help?
General
