NEXT STEPS - LEARN MORE ABOUT YOUR NEW 3D PRINTER
Now that you've run your first print, here's a series of resources to help you set up the REACTOR software,
and learn more about your new EDGE 3D printer.
VARIETY OF DOCUMENTS & RESOURCES AT THE FUSION3 WEBSITE
The Fusion3 website has a robust amount of Technical Support resources for your new EDGE 3D printer.
An important area is the EDGE Manuals & Downloads page (Support > Manuals & Downloads > EDGE 3D
Printer) which contains a number of different documents that detail the setup, use and maintenance of
your EDGE 3D printer.
REACTOR 3D PRINTING SOFTWARE
On the EDGE Manuals & Downloads page, under Software, you’ll find the REACTOR User Manual, which will
assist you with the Installation and use of our REACTOR 3D printing software.
We’ve also prepared a document specifically for the EDGE 3D printer called “Using REACTOR with EDGE”.
INFORMATION ABOUT CONSUMABLES
Much like tires and windshield wipers on a car, EDGE has some components that are considered
consumables and must be replaced on a regular basis. Learn more about them in the "Information about
Consumables" support document.
To Previous Page
Loading...
