Fusion3 EDGE - User Manual

EDGE 3D Printer
QUICKSTART GUIDE
Revision 3/17/2022
PLEASE READ THIS DOCUMENT
BEFORE OPERATING YOUR NEW 3D PRINTER

Summary

Unpacking and Initial Setup

Inspect Shipping and Packaging

Inspect packaging for damage, check Shockwatch, and retain materials for future transport.

Remove Shipping Fixtures and Protection

Setting Up the Fusion3 EDGE Printer

Choosing a Printer Location

Remove Shipping Fixtures and Install Rollers

Connecting Power and First Power Up

Power Connection and Voltage Check

First Power Up and Setup Wizard

Power on the printer, watch the welcome video, and complete the 'first run' wizard for initial setup.

First Print and Filament Loading

Prepare for Printing and Load Filament

Initiate and Monitor First Print

Select a print file, confirm the job, and monitor the printer's heating and printing sequence.

Load Filament into Extruder

Steps to adjust spool rollers, place spool, open door, trim filament, feed into extruder, and advance.

Extruder Operation and Maintenance

Operating the Extruder Feed Section

Print Bed Management and Preparation

Cleaning the Glass Print Surface

Applying Bed Coatings for Adhesion

Safety and Troubleshooting

Cautions and Operating Warnings

Important warnings on unattended operation, hot components, electrical shock hazards, and unauthorized modifications.

Handling Printing Issues

Procedures for addressing issues encountered during or before a print, focusing on pausing and error checking.

Fusion3 EDGE Specifications

General

Print Speed	up to 250 mm/s
Filament Diameter	1.75 mm
Connectivity	USB, Ethernet, Wi-Fi
Nozzle Temperature	Up to 300°C
Heated Bed Temperature	up to 140°C
Frame	Aluminum
Build Volume	355 x 355 x 315 mm
Nozzle Diameter	0.4 mm
Supported Materials	PLA, ABS, PETG, Nylon
Weight	45 kg
Power Requirements	50-60Hz