2. Open your operator's toolkit and
locate the power cord.
3. Insert the power cord into the
power outlet on the back of your
printer.
4. Insert the other end into a wall
outlet capable of delivering 6 amps
continuous power.
5. (Optional) Insert an ethernet cable
to connect your printer to your
wired network. If you wish to use
the onboard WiFi, configuring your
network is covered later.
FIRST POWER UP
1. Press the power switch to the "on"
or "I" position. Your printer may
take 1-2 minutes to boot fully.
2. You will see a short welcome video
play; this confirms your printer has
correctly booted up.
3. After the video, a "first run" wizard
will walk you through checking all
the printer's functions and making
sure everything is working
correctly. This should take less
than 10 minutes, but it's very
important you do not skip it! (This
wizard will only run the first time
you power on the machine.)
IMPORTANT: If you encounter a
problem during this first run script, contact Fusion3 Customer Support. PLEASE DO NOT attempt
to bypass or fix an issue yourself; what has likely happened is related to shipping damage and we
want to make sure we completely and thoroughly fix the problem for you.
To Next Page
Loading...
