FUTABA 8FG - Page 107

107
0RGHO0HQX$LUSODQH*OLGHU)XQFWLRQV!
6HWWLQJPHWKRG
Ɣ0DVWHUVLQJOHPRGHVHOHFWLRQ
Move the cursor to the [MODE] item and
touch the RTN button to switch to the data
input mode. Select the master or single
mode by scrolling the touch sensor.
*The display blinks.
[MASTER]: Master mode
[SINGLE]: Single mode
Touch the RTN button to select the mode
and return to the cursor mode.
When setting a master switch, move the
cursor to the [MASTER-SW] item and touch
the RTN button to access the selection
screen. Select the switch and set its ON
direction.
)RUDGHVFULSWLRQRIWKHVZLWFKVHOHFWLRQPHWKRGVHHWKH
description at the back of this manual.
When setting a safety switch, move the
cursor to the [SAFETY-SW] item and touch the
RTN button to access the selection screen.
Select the switch and set its ON direction.
Ɣ'LUHFWLRQVZLWFKVHOHFWLRQ
Move the cursor to the direction switch item
and touch the RTN button to access the
selection screen. Select the switch and set its
ON direction.
)RUDGHVFULSWLRQRIWKHVZLWFKVHOHFWLRQPHWKRGVHHWKH
description at the back of this manual.
Ɣ5DWHDGMXVWPHQW
Move the cursor to the aileron, elevator or
rudder item for each direction and touch the
RTN button to switch to the data input mode.
Adjust the rate independently by scrolling
the touch sensor.
Initial value: (Dependent upon the snap roll
direction)
 $GMXVWPHQWUDQJHa
:KHQWKH571EXWWRQLVWRXFKHGIRURQHVHFRQGWKHUDWHLV
UHVHWWRWKHLQLWLDOYDOXH
Touch the RTN button to end the adjustment
and return to the cursor mode.