FUTABA 8FG - Page 73

73
0RGHO0HQX&RPPRQ)XQFWLRQV!
'XDOUDWHVHWWLQJSURFHGXUH
1. Function selection
Move the cursor to the function selection
item and touch the RTN button to switch to
the data input mode.
Select the function you want to adjust by
scrolling the touch sensor.
Touch the RTN button to the cursor mode.
2. Switch selection
Move the cursor to the circuit # item and
access the switch setup screen by touching
the RTN button. Select the switch activation
method and the activation position (if
applicable).
)RUDGHWDLOHGGHVFULSWLRQRIWKHVHWWLQJPHWKRGVHH>6ZLWFK
6HWWLQJ0HWKRG@DWWKHEDFNRIWKLVPDQXDO
3. Left/right (up/down) rate adjustment
3HUIRUPWKHVHWWLQJVEHORZDIWHUFKDQJLQJWRWKHFLUFXLWRU
FRQGLWLRQ\RXZDQWWRDGMXVW
Move the cursor to the rate item you want to
adjust and touch the RTN button to switch to
the data input mode.
Adjust the rate by scrolling the touch sensor.
 ,QLWLDOYDOXH
 $GMXVWPHQWUDQJHa
:KHQWKH571EXWWRQLVWRXFKHGIRURQHVHFRQGWKHVHUYR
RSHUDWLRQSRVLWLRQLVUHVHWWRWKHLQLWLDOYDOXH
Touch the RTN button to end the adjustment
and return to the cursor mode.
Repeat this procedure for additional rate
and other functions as desired.
4. Operation curve (EXP curve) adjustment
3HUIRUPWKHVHWWLQJVEHORZDIWHUFKDQJLQJWRWKHFLUFXLWRU
FRQGLWLRQ\RXZDQWWRDGMXVW
Move the cursor to the EXP item you want to
adjust and touch the RTN button to switch to
the data input mode.
Adjust the rate by scrolling the touch sensor.
 ,QLWLDOYDOXH
 $GMXVWPHQWUDQJHa
:KHQWKH571EXWWRQLVWRXFKHGIRURQHVHFRQGWKHVHUYR
RSHUDWLRQSRVLWLRQLVUHVHWWRWKHLQLWLDOYDOXH
8VLQJWKH(;3FXUYHLVHIIHFWLYHWRVPRRWKHRUVRIWHQWKH
control inputs around center to avoid over-controlling the
PRGHO7KLVLVRIWHQXVHGIRUWKHDLOHURQVHOHYDWRUDQG
UXGGHUDQGPD\EHXVHGZLWKWKHWKURWWOHLQWKHFDVHRIDQ
DLUSODQHVHOHFWLRQWRVPRRWKHWKHHQJLQHFRQWUROVDVZHOO
Touch the RTN button to end adjustment and
return to the cursor mode.
Repeat this procedure for all other rates and
functions as desired.