FUTABA 8UAFS - Control Layout and Switch Assignments

8
Dust cap
(optional memory module plugs in here)
CH8 knob
Flap trim control
This controls CH6, and if flaperon
mixing is activated controls the flap
trim.
Switch B
Rudder dual rate switch
Switch A
Elevator dual rate switch
Switch F
Snap roll switch
or trainer switch
Switch E
Landing gear switch
/CH5
Rudder/Throttle stick
Throttle trim lever
Rudder trim lever
Large LCD panel
Power switch
Up position: ON
Hook for optional neckstrap
Edit keys
Snap roll direction switch
Aileron trim lever
Elevator trim lever
Elevator/Aileron stick
Switch G
Switch H
Programmable mixing switch
Switch D
Aileron dual rate switch
Switch C
Elevator - flap mixing or
airbrake mixing switch
Spoiler/CH7 control
This knob is disabled if aileron differantial
is activated.
Carrying handle
Antenna
Antenna must be fully extended when flying.
Be careful not to bend your antenna when you
collapse or extend it.
DataPac
EXTRAMEMORYMODULE
POWER
A
B
ELE.D/R
RUD.D/R
C
D
AIR.BRAKE
AIL.D/R
ELE‑FLP