RECEIVER FP-R118GP
•The
receiver
of
this
set
is
a
miniature PCM
re-
ceiver in which the highest reliability has been
pursued. It is the first R/C receiver in the world
to incorporate the newest computer technology.
• Miniature PCM receiver with high speed single
microprocessor. Resistance to adjacent band and
spark noise interference has been increased by
one full order of magnitude.
• Microprocessor servo hold function eliminates
erroneous operation
when
a
"dead
point"
area
is entered.
• Microprocessor provides fail safe and battery fail
safe functions for greater safety.
• Error lamp display allows checking of the receiv-
er operating state.
• DC-DC converter in the power supply improves
low-voltage operation characteristics.
• High sensitivity design with RF amplifier.
• Ultra narrow-band ceramic filter and PCM sys-
tem are invulnerable to adjacent band inter-
ference.
• Gold plated connector pins eliminate poor con-
tact. Polarized housing improves reliability
against shock and vibration.
•
DSC
circuit. Each
servo
can be
controlled
from
the transmitter without turning on the transmit-
ter by connecting the transmitter directly to the
C terminal.
SERVO FP-S130
•Small, double ball bearing, water-tight & dust-
tight servo. High output torque 55.6 oz-in (5kg-
cm), high-speed .24sec/60 .
• New indirect drive potentiometer improves
vibration and shock resistance and neutral
precision.
• Futaba low-power custom 1C provides high start-
ing torque, narrow dead band, and excellent
trackability.
• Fiberglass reinforced PBT (polybutylene ter-
ephthalate) molded servo case is mechanically
strong and invulnerable to glow fuel.
• Strong polyacetal resin ultra-precision servo gear
features smooth operation, positive neutral, and
very little backlash.
• Fiberglass reinforced epoxy resin PC board with
thru-the-hole plating improves servo amp vibra-
tion
and shock
resistance.
•Thick
gold
plated connector pins
ensure
positive
contact and improve reliability against shock and
vibration. The connector housing is polarized to
prevent reverse insertion.
• Six special adjustable splined horns.
SERVO FP-S130G
•Small
retractable
landing
gear
servo
with
high
class
5-pole
micromotor.
High
output
torque
4.7kg-cm, high-speed 0.34sec/60°, waterproof
type.
•Since forward/reverse operation is controlled by
the pulse width of the signal generated by turn-
ing the transmitter snap switch on and off, the
motor stops at the end of its throw in either
direction.
• Unlike other proportional servos, motor drive
current does not flow when the servo is stopped
even if a load is applied. Thus current drain is
extremely low.
• Fiberglass reinforced PBT (polybutylene ter-
ephthalate) injection molded servo case is me-
chanically strong and invulnerable to glow fuel.
•Strong
polyacetal
resin
ultra-precision
servo
gear
features smooth operation, positive neutral, and
very little backlash.
•
Fiberglass
reinforced
epoxy
resin PC
board
with
thru-the-hole plating improves servo amp vibra-
tion
and shock
resistance.
•Thick gold plated connector pins ensure positive
contact and improve reliability against shock and
vibration. The connector housing is polarized to
prevent reverse insertion.
To Next Page
Loading...
