FUTABA Magnum Sport FP-2P - TRANSMITTER FP-T2 P HANDLING INSTRUCTIONS; Transmitter Components; Battery Installation

TRANSMITTER FP-T2P HANDLING INSTRUCTIONS
The name of each part of the transmitter
is shown in Fig. 1 and Fig. 2. Learn them
(2
Antenna
—________________Z»
before
operating
your
set.
@)Steering
(rudder)
trim
©
Steering
(rudder)
servo
reversing
switch
() Level meter
a
Power switch
WOARL O LE ADING MANUFAC TURE R
t —
OF RADIO CONTR
@ Steering wheel (rudder) Hi | 5 ==] | I ]
@ Throttle tim_—______ W_ WF ca f ee Wi ~~~ OWheel tension adjuster
Lee
(8)Wheel angle adjuster @Throttle trigger (throttle)
(5) Throttle neutral adjuster
4 A ‘
ay ee ether de Cova ht
. ry * $
Servo reversing switch positions are:
Left (NORM) side....Forward rotation
Right (REV) side....Reverse rotation
REV
D Throttie servo
reversing switch
6©)Steering (rudder) servo
reversing switch Fig. 3
(Battery cover Slide in the arrow direction
while pressing here.
Fig. 2
@ Remove the battery cover and load eight penlight batteries into
the battery holder in the correct polarity.
e When the antenna is extended to its full length and the power
switch is turned on, the level pointer should deflect to within
the silver zone. If the pointer does not deflect, or deflects very
little, check for poor battery contact, incorrect battery polarity,
Battery holder or faulty batteries.