FUTABA T26SZ - Page 111

111
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŷƈƏƈƐƈƗƕƜŃŝŃŶťŶŐœŔŰůŃƉƒƕŃųƌƛƋƄƚƎǜŃ
7KH6%60/GLVSOD\VWHOHPHWU\GDWDIURPWKHGURQHÀLJKWFRQWUROOHU3L[KDZN
◆ RegisterSBS-01MLtotransmitterbymethod1or2.
ConnecttheSBS-01MLtotheS.I/F
connectoronthebackofthetransmitter.
◆ Linkagemenu → Sensor → 3/3
◆ Linkagemenu → Sensor
１. Registrationtotransmitter
2. Manualregistrationmethod
TELEMPort
S.BUS2Receiver
S.BUS2Port
S.BUSPort
S.BUSPort
Pixhawk
Futaba
T26SZ
Tap8or16todisplaya
listofsensorsthatcanbe
registered.TapSBS-01MLto
register.
● Callpage3of[Sensor].
*Please note that the proper default slot for this accessory is number
16 (8-16).
This sensor uses eight slots. Being made to a start
slot are
8 and 16.
ConnecttheSBS-01MLto
thetransmitterasshown,
thentapRegister.
Registrationiscompletewhen
thisscreenappears
Completeregistrationandremove
SBS-01MLfromthetransmitter.
ŷƋƈŃƇƈƉƄƘƏƗŃƖƏƒƗŃƉƒƕŃŶťŶŐœŔŰůŃƌƖŃ
ņŔřőŃźƋƈƑŃƘƖƌƑƊŃņśŏŃƆƋƄƑƊƈŃƗƋƈŃ
ŶťŶŐœŔŰůŃƖƏƒƗŃƄƆƆƒƕƇƌƑƊŃƗƒŃƗƋƈŃ
ƓƕƒƆƈƇƘƕƈŃƒƑŃƓƄƊƈŃś9ő
*When using FASSTest26CH, update SBS-01ML to Ver.2~.