FUXTEC FX-RT226 User Manual

Original Bedienungsanleitung FUXTEC FX-RT226_rev02
40
Installing the plastic shield
Install the safety cover on the shaft with the safety
cover bracket and screws provided. Tighten the
screw after setting the safety cover bracket at the
appropriate position
INSTALLING NYLON LINE CUTTER HEAD
Step 1:
Align hole in adapter plate with hole in shaft and install
locking tool.
Step 2:
Thread cutter head onto shaft (turning it clockwise)
until it is tight. Remove locking tool
Warning!
EXCESSIVE VIBRATION-STOP ENGINE IMMEDIATELY Excessive vibration of blade means
that it is not properly installed. Stop engine immediately and check blade. Blade
improperly installed will cause injury. Use only our company original cutting equipment
parts when servicing the unit
WHEN MIXING GASOLINE WITH TWO CYCLE ENGINE OIL, USE ONLY GASOLINE
WHICH CONTAINS NO ETHANOL OR METHANOL(TYPES OF ALCOHOL). THIS
WILL HELP TO AVOID POSSIBLE DAMAGE TO ENGINE FUEL LINES AND OTHER
ENGINE PARTS. DO NOT MIX GASOLINE AND OIL DIRECTLY IN THE ENGINE
FUEL TANK.
IMPORTANT: Failure to follow proper fuel mix instructions may cause damage
to the engine.

FUXTEC FX-RT226 Specifications

General

Brand	FUXTEC
Model	FX-RT226
Category	Brush Cutter
Language	English