EasyManua.ls Logo

FUXTEC FX-RT226 - Page 41

FUXTEC FX-RT226
52 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Original Bedienungsanleitung FUXTEC FX-RT226_rev02
41
1. When preparing fuel mixture, mix only the amount needed for the job you
are to do. Do not use fuel that has been stored longer than two months. Fuel
mixture stored longer than this will cause hard starting and poor performance.
If fuel mix has been stored longer than this time, it should be removed and
filled with fresh mixture.
WARNING DANGER 2.Never fill the fuel tank to the very top.(under 3/4 of the
tank) 3.Never add fuel to the tank in a closed non-ventilated area. 4.Do not add
fuel to this unit close to an open fire or sparks. 5.Be sure to wipe off spilled fuel
before attempting to start engine 6.Do not attempt to refuel a hot engine.
CHECK POINTS BEFORE OPERATION 1.Check for loose bolts, nuts and fittings.
2.Check the air cleaner for dirt. Clean the air filter of all dirt, etc. before
operation. 3.Check to be sure that protector is securely in place. 4.Check to be
sure that fuel is not leak. 5.Check to be sure that blade is no crack.
Mix fuel with 2-stroke oil in a dedicated container. Note
The mixing table of the following page for correct fuel ratio to the oil. Shake the
container to ensure complete mix.
.
WARNING: Lack of lubrication excludes the liability of the machine manufacturers.
Petrol and oil must be mixed in a ratio of 40:1
gasoline 2-stroke oil (40:1) gasoline 2-stroke oil (40:1)
1 Liter 0,025 Liter 5 Liter 0,125 Liter
2 Liter 0,050 Liter 10 Liter 0,250 Liter

Related product manuals