G-U ELTRAL KS 30/40 RADIO CONTROL User Manual

11
10.2016 | G28706 | Designed in Germany
Switching off in the closed position
The drive switches off via the integrated load cut-off in the closed position. The limit switches
therefore do not need to be adjusted. When the end position is reached, the drive reverses
approx. 1 mm. This relieves the load on the gaskets as well as the fastening brackets.
Setting the travel
The travel of the chain drive is set at the factory to 400 mm.
The travel can be changed at any time via the DIP switches. These are under the cover. Only
the settings of DIP switches 1 and 2 have to be changed as indicated in the table below. To
apply the change, the chain must be extended slightly then retracted.
After this a test run should be completed.
Travel [mm]
DIP switch
12
100 OFF OFF
200 ON OFF
300 OFF ON
400 ON ON
Handheld radio transmitter
The ELTRAL KS 30/40 RADIO CONTROL chain drive is operated exclusively using the
KS 30/40 handheld radio transmitter (Order No. K-19046-00-0-0). It cannot be operated using
handheld transmitters by other manufacturers.
For more details on the characteristics and functional principle, please refer to the operating
instructions enclosed with the handheld radio transmitter. Read the operating instructions for
the handheld radio transmitter fi rst, and observe the directions given. The transmitter is not
programmed at the factory.
The radio transmission frequency is 433.92 mHz and has a variable code ("Rollcode") with 16
billion possible combinations. The code changes with every transmission operation according to
an algorithm that conceals the code used thus ensuring an optimum degree of security.
Several drives can be controlled via the handheld radio transmitter, in which case every channel
must be assigned to an ELTRAL KS30/40 RADIO CONTROL drive and therefore a window.
The handheld radio transmitter has 30 channels which means that up to 30 windows can be
controlled individually. A maximum of 15 handheld radio transmitters can be stored on every drive.
Several channels can be combined into a group so that several drives can be activated
simultaneously at the push of a button. A maximum of 2 groups each containing 10 channels
can be programmed.
Special applications, such as an automatic ventilation function, can be programmed at the
factory via function buttons. These function buttons cannot be programmed individually by the
user.
1
ON
Travel 100 mm
Switch shown
in "ON" position
Travel 300 mm
Travel 400 mm
Travel 200 mm
2
1
ON
2
1
ON
2
1
ON
2
1
ON

G-U ELTRAL KS 30/40 RADIO CONTROL Specifications

General

Brand	G-U
Model	ELTRAL KS 30/40 RADIO CONTROL
Category	DC Drives
Language	English