9
10.2016 | G28706 | Designed in Germany
8 Mounting the device
ATTENTION
Risk of inappropriate assembly
The device must be assembled by trained and qualifi ed persons only.
After mounting the hardware, make sure it is working correctly.
Carefully follow the enclosed installation drawings.
DANGER
Risk of crushing
During the automatic opening and closing of the window, push and pull
forces of up to 300 N occur. These forces are capable of crushing limbs
should you reach into the area between the sash and the frame. In
particular because in the event of a jam the motor will attempt repeatedly
to complete travel.
Keep children, disabled persons, and animals away from the window.
Do not reach between sash and frame when the motor is running.
In the case of a window sash installed below 2.50 m, secure
all crushing and shearing points to ensure that persons do not
accidentally reach into them. Observe VFF code of practise KB.01:
Power-Operated Windows.
DANGER
Risk of injury
Motor-driven Tilt-Only windows must always be equipped with a safety
catch to prevent injury caused by falling sashes.
Furthermore, there is a risk of injury when assembling the motor on a
window that has already been installed if the sash opens suddenly.
Always use appropriate safety devices such as security stays to catch
the window.
The safety stay must be adapted to the opening width of the drive. To
avoid jamming, the opening width of the safety stay must exceed that
of the drive.
Install the motor in a way that it is always accessible.
Follow the installation drawing. This is enclosed in the fi xing set or can be obtained
from your nearest subsidiary and contains the dimensions for the various installation
methods and profi le systems.
All dimensions of the particular installation are the responsibility of the installer;
adjustments may be necessary.
Before working on the profi les, take note of the following:
Minimum sash width
Minimum sash height
Maximum sash weight
Possible wind and snow loads
Space required on the profi le according to the assembly method.
Check the required minimum distances.
Perform a function check. For this purpose, use the proper GU testing and setting
apparatus (see section "11 Components and accessories" on page 14).
To Next Page
Loading...
Need help?
General
