Gabarron PH-125 Plus - Page 4

3
EN
3.- USING THE PANEL HEATER
DIGITAL CONTROL WITH DAILY AND WEEKLY PROGRAMMING
Main switch:
All models are equipped with one switch on the right surface allowing the panel
heater disconnection.
Ph Plus panel heaters have built in an electronic thermostat with a sensibility of 0.1 ºC. It is
possible to set temperatures with an accuracy of 0.5ºC.
The daily or weekly programmer (selectable) allows you to allocate three different temperature
levels to any of the 48 intervals of 30 minutes of the day.
Digital DISPLAY:
It shows the time, temperature
and other messages.
Frost protection key:
If the display shows the time the
heater is in frost protection mode.
Press this key to shift from frost
protection mode to standard mode
and vice versa.
Heating indicator:
This small dot will be lit when
the heater is consuming energy.
SUN indicator
Press this key for more than
two seconds to set the time or
day of the week.
PRG key:
Allows you to create check or
modify programs.
Move forward with + or – keys
and allocate the SUN, MOON, or
 temperature to any of the 48
intervals of 30 minutes of the day
by means of the relevant key.
Key “+”:
It increases the values.
SUN key:
Press once to see the SUN
temperature value.
Press + or – keys to modify the
value.
MOON key:
Press once to see the MOON
temperature value. Press + or
– keys to modify the value.
MOON indicator
Key “-”:
It decreases the values.