SWITCHING ON THE PANEL HEATER
Once the heater is connected to a main supply, switch on the heater by setting the switch marked I-O positioned at the rigth
side of the panel heater to “I”. The off position is marked “O”.
SETTING THE TIME
Press the key more than two seconds. The display will show the time intermittently. Set the hours by pressing + and - keys
and press the . Set the minutes the same way. Press once more the key to store the time. If at any time it is necessary to
set the time press the key and repeat the above steps.
FROST PROTECTION MODE
With this mode on, if the room temperature drops below 3ºC the heater will connect itself automatically.
If the display shows the time the panel heater is in frost protection mode. Press the key to shift from frost protection mode
(time is shown in the display) to standard mode (temperature is shown in the display) and vice versa.
PROGRAMMING THE PANEL HEATER
The panel heater operates in programming mode maintaining the SUN, MOON or temperatures as per the introduced
program. If the display shows the time, the panel heater is in frost protection mode.
SUN, MOON AND TEMPERATURES
The electronic programmer is able to handle three temperature levels during the 24h of the day.
Press the key to set the SUN temperature. The display will show the SUN temperature value blinking.
Set the SUN temperature value by means of the + o – keys and press the key to store the value. If the display shows the
time the heater is in frost protection mode. Press the key to shift from frost protection mode (time is shown in the display)
to standard mode (temperature is shown in the display) and vice versa.
Repeat the above steps with the key to set the MOON temperature.
The temperature level is 3ºC and it is a fix value. This temperature level can be used as off selection when setting the
temperatures during curtain times of the day.
SUN, MOON, or temperatures can be allocated to any of the 48 intervals of 30 minutes of the day.
DAILY PROGRAMMES
It is basic to visualize the day split into 48 intervals of 30 minutes each; SUN, MOON, or temperatures can be allocated to
any of them.
The default settings include daily mode so that the heater will repeat the program every day. If different programmes are
required along a week, please see the next step WEEKLY PROGRAMMES. To check a programme or to make a new one,
follow these steps:
Press the PRG key and the display will show 00:00 intermittently. Press one of the three keys to allocate SUN,
MOON or OFF (frost protection) from 00:00h to 00:30h. If SUN or MOON temperatures are selected the relevant luminous
indicator will be lit. If OFF temperature is selected both luminous indicators will be off.
To Next Page
Loading...
