WEEKLY PROGRAMMES
It is possible to allocate different programs to different days of the week. To do this, the controller has to be upgrade from
24hr mode (factory default) to 24hr/7days mode as follows:
Switch off the panel heater by turning off the main switch at the right side of the heater, the display will be Off. Press the
key and at the same time turn on the main switch maintaining the key at least five seconds. The display will show P-SE
which means that weekly mode has been set.
SETTING THE DAY: Press the key more than two seconds and the display will show the number of the day. Set the correct
number, if required, by pressing + or – keys. Press the key and the display will show now the time. Press again the key
and new values will be stored.
To check a programme or to make a new one press PRG key: The display will show dia1. Press again PRG key and the
display will show 00:00 intermittently. Follow now the steps from DAILY PROGRAMMES section until the display shows
again dia1. Repeat this process with the 7 days of the week. When the display shows dia7 the weekly program will be stored
by pressing + key.
If the display shows dia1 then, pressing + key more than three seconds will copy the day 1 program to day 2
and so on.
It is possible to allocate any of the three temperature levels to all the intervals of any day maintaining the
relevant key until an audible signal is heard.
To turn back a controller from 24hr/7days to a single 24hr press PRG key more than six seconds. This will restore the factory
default settings.
KEYBOARD LOCK
Press the key more than six seconds and the keyboard will be locked. The display will show and the controller
will keep on working internally. To unlock the keyboard, press again the key more than six seconds.
SUN MANUAL OVERRIDE
Maintain the SUN Key pressed for 4 seconds to set the Sun Manual Override. The heater will maintain the sun temperature set
point and will ignore the pre-set program until the next change in programming temperature level.
Both luminous indicators SUN and MOON will be lit. This function could be useful when SUN temperature is required and we
do not want to modify the program.
By pressing the SUN key for 4 seconds with Sun Manual Override activated, the function will be removed and the heater will
follow the programme again.
To Next Page
Loading...
