POST STERILIZATION CYCLE
18
› Once the sterilization cycle has finished and the working day is at the end, turn off
the machine using the switch on/off in the corner down at right on the frontal side
of the autoclave.
› Make sure to leave the door partially open to let the machine cool.
› If you want to set a new sterilization cycle do once again the procedure
previously described.
NOTE:
If “standby” mood or energy saving is on, NIGHT CYCLE, the machine automatically
switches off after 30 mins from the last sterilization cycle. This happens only if “Poer”
function has been activated during installation. (See manual).
To Next Page
Loading...
