GALBIATI PRIMA - AUTOCLAVE TEST PROGRAMS; HELIX;B&D and VACUUM Test Programs; PIPELINE CLEANING PROGRAM

TEST PROGRAMS
FOR AUTOCLAVE FUNCTIONS
PIPELINE CLEANING PROGRAM
17
a. HELIX/B&D test lighting signal:
(see user manual, page 23)
› Press TEST button (1) and
select HELIX/B&D test program;
› Press START button (2) to go on.
NOTE: This is a forced water circulation process that clean pipes,
valves and steam generator. The time of the cycle is 1 minute.
Pipeline cleaning lighting signal:
› To start the pipeline cleaning program, press TEST button (1) until you select the
pipeline cleaning lighting signal;
› The pipeline cleaning lighting signal will shine on, so press START button (2) to go on.
b. VACUUM Test Lighting signal:
(see user manual, page 23)
› Press TEST button (1) until you
select VACUUM test program;
› Press START button (2) to go on.
b.a.
1
1
2
2