DISTILLED WATER FILLING
ADD DISTILLED WATER IN THE TANK
CAN BE DONE FOLLOWING TWO WAYS:
9
After switching on the autoclave, if water level in the tank is low the indicator will
lighten and an acoustic signal will follow in order to indicate lack of water. So if you want
to set up the sterilization cycle you’ll have to add distilled water before doing that.
STEP 1:
Open the tank cover
on the upper side of
the sterilizer at right.
STEP 3:
After pouring distilled
water, close the
tank cover.
STEP 2:
Pour manually distilled water
until the lighting indicator
turns off or when you hear
a short sound.
DISTILLED WATER FILLING
NOTE: Otherwise, an acoustic signal
will follow and the indicator
will lighten.
NOTE:
A. MANUALLY ADD:
To Next Page
Loading...