Galcon 9001 E-Z - Battery Installation; Controller Installation

 Hold the controller with the baery compartment facing
you (part 5).
 Remove the baery compartment cover.
 Connect a 9V baery to the baery connector.
 Insert the baery in the compartment and press down
the baery compartment cover.
Always insert the front part (1) rst and then
press down the rear part.
 Aenon: Ascertain that the baery compartment is dry
when replacing the baery.
 Use an Alkaline baery only.
2. Baery Installaon
3. Controller Installaon
 Aach the tap joint adapter (part No. 1 in Page No. 1) to
the tap's orice and turn the adapter counter clockwise,
unl completely locked. Hand ghten only.
 Join the irrigaon system to the outlet of the controller
(part No. 4 in Page No. 1).