Galcon 9001 E-Z User Manual

4. Irrigaon Programming
1. Open the top cover.
2. Set the irrigaon me selector to the desired irrigaon duraon.
3. Set the irrigaon cycle me selector to the desired cycle me.
4. Press the "START" switch.
The tap will open immediately and the irrigaon will commence, for
the set duraon and cycle mes.
For example:
• If you set the irrigaon cycle me selector to "1 Day" and the
irrigaon me selector to "30 MIN". The tap will open immediately
upon pressing the "START” switch and will remain open for 30
minutes. The tap will open at the same me on the following day
for 30 minutes everyday.
 The tap will open every day at the me you pressed the switch on
the rst day.
Please note: You can change the irrigaon duraon and the cycle
me even aer you acvate the program by changing the sengs
of the selectors.
5. Programming an Irrigaon
Controller with a Delayed
Opening Time
For Example, a 3 Hr irrigaon, once every 3 days program,
programmed to start 6 Hr later.
1. Set the irrigaon me selector to 3 Hr.
2. Set the irrigaon cycle me selector to "Delay".
3. Press and hold the "START* switch unl you hear G clicks,
including the rst click, (the number of clicks corresponds to the
number of delay hours before the controller opens the tap for the
rst me).
4. Set the irrigaon cycle me selector to "3 Days".
When you set an odd number of delay hours you will hear an
addional click a few seconds aer releasing the switch. This click
keeps the tap closed unl its rst opening.
*To change the opening hour, remove the baeries for 3 minute.
Program the controller from the start aer replacing the baeries.
6. Maintenance
Remove the baery if the irrigaon controller will not be used for a
prolonged me. Remove the lter and clean it periodically (every
few months). Failure to clean the lter may cause problems.
Esmated life span of the baery is one year at least.

Galcon 9001 E-Z Specifications

General

Brand	Galcon
Model	9001 E-Z
Category	Controller
Language	English