Gallagher S16 - TIPS & TROUBLESHOOTING

10
TIPS & TROUBLESHOOTING
• Install energizer where it can get plenty of sunlight.
• Keep solar panel surface clean - periodically use a so cloth with water and a
mild detergent.
• Test voltage on the fence using a Gallagher Fence Volt Meter (G50301).
• Turn energizer o before handling fence or baery connecons.
Problem 
Indicator ashing red • Ensure energizer is geng enough sun.
• Turn energizer OFF for 3 days, leave in the sun to
charge baery OR remove the baery from the
energizer and charge the baery for 24 hours
with a 6V 1.2A charger in a sheltered, well-
venlated area.
No voltage on fence • Check energizer isn’t faulty;
- disconnect from fence and earth
- measure across fence and earth terminals
with a Gallagher Fence Volt Meter
- if less than 5 kV return energizer for service
- if more than 5 kV the fault is with the fence
or earth system.