What to do if there is no voltage on my Gallagher Power Supply fence?
If there is no voltage on the fence, first check that the energizer isn’t faulty by disconnecting it from the fence and earth. Then, measure across the fence and earth terminals with a Gallagher Fence Volt Meter. If the reading is less than 5 kV, return the energizer for service. If it's more than 5 kV, the issue lies with the fence or earth system.
Why is the indicator flashing red on my Gallagher Power Supply?
If the indicator on your Gallagher Power Supply is flashing red, ensure the energizer is receiving sufficient sunlight. If not, turn the energizer OFF for three days and leave it in direct sunlight to allow the battery to charge. Alternatively, remove the battery and use a 6 V 1.2 A charger to charge it.
What to do if Gallagher Power Supply indicator flashes red twice then stops?
If the indicator on your Gallagher Power Supply flashes red twice when turned on and then stops, perform the following steps: Ensure the energizer is getting enough sun, turn the energizer OFF for 3 days leaving it in the sun to charge the battery, or remove the battery and use a 6 V 1.2 A charger to charge it. If the issue persists, replace the battery.
General| Brand | Gallagher |
|---|---|
| Model | S10 |
| Category | Power Supply |
| Language | English |
Covers warnings on contact with fence wires, entanglement, supervision of children, and mains connection.
Details on fence wiring, earthing systems, wire separation, and use of barbed wire.
Rules for avoiding and crossing power lines and guidelines for connecting leads.
Steps for opening the energizer, connecting the battery, and closing the cover.
Instructions for installing the energizer, ensuring correct solar panel orientation.
Instructions for connecting the green terminal to the earth stake and the red terminal to the fence line.
Guidance on switching the energizer on and understanding the battery indicator status.
Advice on positioning the energizer for sunlight and maintaining the solar panel surface.
Solutions for indicator lights flashing red, no voltage on fence, and battery maintenance.
To Next Page
