Gamma Active - Care and Maintenance; Cleaning the Monitor

EN
17
E1: Can’t normally
increase pressure
Check your wrist cuff for
air leakage
Replace wrist cuff with
new one
E3: Inate pressure
too high
Remeasure or send back
to dealer to recalibrate
E2 E4: Hand
shaking while
measurement
Hand or body shaking
while measurement
Keep static position and
measure again
Battery icon on Battery low power
Replace battery and
measure again
The systolic
pressure Value or
diastolic Pressure
value too high
1.The wrist cuff was held
lower than your heart
Keep correct position and
measure again
2.The wrist cuff was not
attached properly
3.You moved your
body or spoke during
measurement
The systolic
pressure value or
diastolic pressure
value too low
1.The wrist cuff was held
higher than your heart
2.You moved your
body or spoke during
measurement
CARE AND MAINTENANCE
To avoid the monitor attracting dirt, dust or other contaminants, wash and dry
your hands thoroughly before use.
Cleaning
• To clean the monitor exterior, wipe it with a cloth moistened with tap water
or a mild cleaning agent, then dry the device with a soft dry cloth. Do NOT
ush with water.
• Do NOT use organic solvents to clean the monitor.
• Do NOT wash the pressure cuff.
• Do NOT iron the pressure cuff.