Gamma Control - Reading Measurement Results; Discontinuing a Measurement

54
WARNING:
If the cuff is relatively lower than the heart, the obtained blood pressure
value could be higher than the actual value. If the cuff is relatively higher
than the heart, the obtained blood pressure value could be lower than the
actual value.
Always apply the pressure cuff before turning on the monitor.
1. Press the ON/OFF button. The built-in compressor begins to inate the
cuff. In the display, the increasing cuff pressure is continually displayed.
2. After automatically reaching an individual pressure, the pump stops
and the pressure slowly falls. The cuff pressure is displayed during the
measurement. When the device has detected your pulse, the heart
symbol on the display begins to blink and a beep tone is audible for every
pulse beat.
Reading Measurement Results
The measured systolic and diastolic blood pressure values, as well as
the pulse are now displayed. The appearance of this symbol
signies
that an irregular heartbeat was detected. This indicator is only a caution.
It is important for you to be relaxed, remain still and do not talk during
measurements.
NOTE: We recommend contacting your physician if you see this indicator
frequently.
Discontinuing a Measurement
If it is necessary to interrupt a blood pressure measurement for any reason
(e.g the patient feels unwell), the ON/OFF button be pressed at any time.
The device then immediately lowers the cuff pressure automatically.